Oil Filter Cover?

[NightRider_imp]

The oil filter looks more exposed than the oil cooler and there is an oil cooler cover on the market. Has anyone seen an oil filter cover, chrome or otherwise?

Thanks in advance.

[Lord Popgun]

Haven't seen one, but if one is available, Mr. T would most likely know about it.

[the Ferret]

Never heard of an oil filter being damaged other than in trying to be removed for the initial service. Honda has had this same filter set up on their inline 4's since the late 70's I think.

[Razor]

Haven't seen an aftermarket "filter cover", but PC Racing does make a reuseable filter that has a cast aluminum case. Couple of my friends use them on their bikes, they really like them. FWIW, the 1800 Goldwing and Runes share the same oil filter as the CB1100 (I'm sure there's other models).

Link to PC filter. Good luck!
[url=http://www.youtube.com/watch?v=26IU-Fc6HeU&sns=em]http://www.youtube.com/watch?v=26IU-Fc6HeU&sns=em

[Gumby 1100_imp]

There is an Oil Cooler/Protector available from:
http://www.buckslowers.com/

It is supposed to fit 2.5" Goldwing filters, so it likely will fit the CB.
It should supply some additional cooling, but I don't believe that it provides any protection to the end of the filter (just the sides).

[Gustav_imp]

From K&N you can purchase a chrome replace oil filter:
http://www.knfilters.com/search/product....od=KN-204C

[redbirds_imp]

Anything that struck the oil filter hard enough to damage it would likely cause more serious damage elsewhere. Oil filter housings are tough.

[HikerToo_imp]

From K&N you can purchase a chrome replace oil filter:
http://www.knfilters.com/search/product....od=KN-204C

This is nice looking, not sure if the OP is worried about looks or protection...I assumed looks.

[furious_blue_imp]

There is an Oil Cooler/Protector available from:
http://www.buckslowers.com/

It is supposed to fit 2.5" Goldwing filters, so it likely will fit the CB.
It should supply some additional cooling, but I don't believe that it provides any protection to the end of the filter (just the sides).

More fins ! I like it, but they don't list any Honda motorcycles that it is applicable to.

Now if someone would just a make a set of bolt on header clamp fins...

[NightRider_imp]

No doubt, few have taken a rock into their oil filter out in the middle of nowhere but I suppose it happens since there is an aftermarket oil cooler cover to protect same from that same said rock, the one taken right in the cooler right in the middle of nowhere.

So, I'm looking for protection over looks and I am thinking a rock hurled at 75 mph into my oil filter will punch it open losing oil pressure instantly. But, since one never hears about it I suppose it is over worrying and I also have a few possibilities here but I am loath to buy anything but a Honda filter. So I'm looking for a protective outside case for the standard oil filter rather than a replacement oil filter with a protective case that may work, or not.

Thanks all.