06-17-2019, 02:10 PM
Randy, that's the part. You are correct, the 2013 cover looks a little different.
My main concern, outside of it being unsightly, is that the PCB on the tachometer is now exposed to the elements.
I'm not sure if welding the plastic will work because the plastic piece is somewhat complex and some of the cracks are along inaccessible places. Unless the welding is done with some solvent. I'll look into it a little deeper.
I'm a little surprised that this is only sold as part of a $700 assembly. Below is a picture of how it looks when everything is assembled, the best that it can be right now. The whole assembly is also shifted to the left. It's very obvious when looking at the ignition.
![[Image: 8b9af618993924ec7e2d7d7fd8a695b0.jpg]](https://cb1100forum.net/forum/uploads/imp/201906/8b9af618993924ec7e2d7d7fd8a695b0.jpg)
My main concern, outside of it being unsightly, is that the PCB on the tachometer is now exposed to the elements.
I'm not sure if welding the plastic will work because the plastic piece is somewhat complex and some of the cracks are along inaccessible places. Unless the welding is done with some solvent. I'll look into it a little deeper.
I'm a little surprised that this is only sold as part of a $700 assembly. Below is a picture of how it looks when everything is assembled, the best that it can be right now. The whole assembly is also shifted to the left. It's very obvious when looking at the ignition.