Replacement Meter Back Cover

[jpeppers_imp]

I had the misfortune of low siding last week on my 2014 CB1100. The bike was dropped by the previous owner on both sides and both the crankcase covers were already scratched. That I'm not too beat up about. The problem is that the white plastic backing on the meter assembly cracked and now the whole cluster is lopsided because it's only supported on one side. Is there any way to replace this without buying the entire assembly (37200-MGC-A41)?

It seems ridiculous to spend $600-$700 just to replace a plastic cover. Below is a picture of the damage.