remove the valve cover from the frame (ex 2014)
|
remove the valve cover from the frame (ex 2014)
|
12-01-2020, 11:49 PM
(12-01-2020, 10:38 PM)Lord Popgun_imp Wrote: It only needs it where shown. You should replace the gasket though. My take on that would depend on mileage used (heat cycle) at this point. Example- my bike is low miles- and I've had the valve cover off twice. Looks new, works fine. It is low tq pressure- and quite thick- so not much forced compression. Naturally age will catch up eventually- once the bikes are 20-25 years old, the rubber won't be as happy. |
|
« Next Oldest | Next Newest »
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Valve Adjustment Shims | dave | 4 | 163 |
06-26-2026, 07:17 PM Last Post: Gone in 60 |
|
| Black Frame Paint | spechg | 12 | 744 |
06-24-2026, 08:12 PM Last Post: HondaLou |
|
| Valve Adjustment and Camshaft Removal | dave | 5 | 459 |
03-21-2026, 04:49 PM Last Post: Cormanus |
|
| Valve Adjustment | dave | 6 | 687 |
08-29-2025, 10:46 AM Last Post: dave |
|
| Valve Cover Baffle lining ? | bflint | 6 | 764 |
07-26-2025, 11:27 AM Last Post: bflint |
|
| Valve Adjustment Intervals | CBRider_imp | 32 | 2,249 |
04-21-2025, 02:24 PM Last Post: Jurlie_imp |
|
| How to remove O2 sensor | CB1100AZ_imp | 10 | 698 |
12-13-2024, 09:57 AM Last Post: inditx_imp |
|
| frame gusset threaded hole question | tdbru | 0 | 164 |
10-27-2024, 11:27 AM Last Post: tdbru |
|
| Valve Adjustment Tolerances - How Far Do You Go? | dave | 14 | 1,183 |
10-18-2023, 09:28 PM Last Post: The Gecko_imp |
|
| 2014 CB1100 Right crankcase cover | msundst_imp | 16 | 979 |
06-03-2023, 06:09 AM Last Post: TX Silver_imp |
|
