01-30-2021, 05:33 AM
(01-30-2021, 05:18 AM)bflint_imp Wrote: Getting ready to re-shim my valves after 52K miles. Recommended shim sizes (per calc) either put new clearance on low side or high side of spec (IN 0.006, EX 0.011). I noticed, via calcs, that I could deviate from the recommended shim size to push new clearance from low side to high side or vice versa, while still staying within spec range of +/- 0.001. WHY? Because I noticed that the measured clearances historically show the EXHAUST getting tighter (or staying the same) and the INTAKE getting looser.
*
The recommended shim size for EXHAUST is fine, but I have two choices for INTAKE. For INTAKE I have choice of 0.065 (recommended) or 0.051 new clearance. I was thinking I should pick 0.051 with the assumption that they will loosen over time.
*
General mech theory states that looser is safer. Am i crazy to go to the tight side? Thoughts?
If I was committed to a shim change because I was out of range and I had a choice of the looser end rather than tighter I think I would go the looser. The theory that the clearance always closes up doesn't ring true for many either.