04-17-2021, 03:03 AM
got my bracket from yoshimura today. I fount the stand wasn't that tough too install, The bracket seamed way worse. The hard part was getting the spacers in, but anyways now my center stand is installed and functional finally
![[Image: 58618969f83a9ce6948151c6bee770dc.jpg]](https://cb1100forum.net/forum/uploads/imp/202104/58618969f83a9ce6948151c6bee770dc.jpg)
this is the spacer behind the bracket that's tough to get in. I used a allen key from the back side through the threaded hole to hold the spacer. Then pushed the bracket over and carefully jam the screw in, I used locktite on the screws. yoshi didnt send the locking washers like I ordered but instead 6mm screws mislabeled
![[Image: 58618969f83a9ce6948151c6bee770dc.jpg]](https://cb1100forum.net/forum/uploads/imp/202104/58618969f83a9ce6948151c6bee770dc.jpg)
this is the spacer behind the bracket that's tough to get in. I used a allen key from the back side through the threaded hole to hold the spacer. Then pushed the bracket over and carefully jam the screw in, I used locktite on the screws. yoshi didnt send the locking washers like I ordered but instead 6mm screws mislabeled
