03-30-2022, 01:22 PM
Just had a look at my abs sensor and think that if you were to assemble the brake assembly with some grit in between the brake assembly and the wheel bearing that could space out the sensor away from the slotted ring just enough to stop it from registering the slots, my gap is 0.04 mm. maybe just worth taking it apart and inspect the mating surfaces, just a thought.
And make sure the brake assembly is riding over the square guide on the swingarm to stop it rotating when braking.
And make sure the brake assembly is riding over the square guide on the swingarm to stop it rotating when braking.