03-07-2019, 03:27 AM
Did the original ones have a replaceable lamp inside them?
After watching some video's i wonder; have you turned them too much so the very small wires have broken?
Did you only do the front signals or all four?
From another video it suggests that you can apply 12 volts to the red and black wires, does the orange led light up when mounted inside the handlebar ends?
How did you route the wires to the headlight?
On some models the polarity ( plus and minus ) has been reversed on the REAR indicator lights, you may want to confirm this on your model, do you have a multimeter to check this?
Not clear from the video but with some led's you may need an additional resistor on each side to make the controller "think" all lights are functional by presenting the correct amount of load to it, if one lamp is defective the other lamp will blink faster to indicate a faulty indicator lamp.
Did you test the led's before installing them?
If the led indicators are installed and connected properly the led's should still light up but may be flashing faster, which is not happening according to your post.
After watching some video's i wonder; have you turned them too much so the very small wires have broken?
Did you only do the front signals or all four?
From another video it suggests that you can apply 12 volts to the red and black wires, does the orange led light up when mounted inside the handlebar ends?
How did you route the wires to the headlight?
On some models the polarity ( plus and minus ) has been reversed on the REAR indicator lights, you may want to confirm this on your model, do you have a multimeter to check this?
Not clear from the video but with some led's you may need an additional resistor on each side to make the controller "think" all lights are functional by presenting the correct amount of load to it, if one lamp is defective the other lamp will blink faster to indicate a faulty indicator lamp.
Did you test the led's before installing them?
If the led indicators are installed and connected properly the led's should still light up but may be flashing faster, which is not happening according to your post.