03-08-2023, 09:45 PM
Just for kicks: set your electric impact to tighten, and give it a couple of seconds, then immediately switch the impact to loosen and see if it budges. Another alternative is to use a hand impact tool. Only downsize is it will put stress on the countershaft bearing. If you’re willing to go this route; HF sells them. Make sure to get the 1/2’ drive set. That way you can use an impact socket. Good luck!
Link to the HF hand impact. These come in handy for other jobs too.
https://www.harborfreight.com/6-bit-impa...64812.html
Link to the HF hand impact. These come in handy for other jobs too.
https://www.harborfreight.com/6-bit-impa...64812.html