04-28-2014, 02:22 AM
Put bike on the center-stand. Loosen the lower triple on both sides (see photo) and the two bolts (see photo ) both sides. I would also loosen the axle bolt two turns not sure if this is necessary. Take the bike off center-stand and with force compress the shocks. See if the reading now comes closer to ferrets at about 2 3/4 with compression backed out to four lines showing. If all is well put bike back on center-stand tighten everything up with a torque wrench to spec. I believe you tighten all the bolts before the axle bolt, refer to manual.