Hepco and Becker c-bow mounts and street bags

[DaSwami_imp]

Oldgoat...my street bags side and rear are due in today, I already have the CBow mounts but too cold to install, my question is whether you remove the OEM hand rails or install over them?

Thanks

If you look closely at the second picture, you can see how there are brackets attached to the rails. These provide the necessary offset for the lights. The c-bow mounts are attached to these brackets. It's so simple, even I wasn't able to mess them up. The only challenging part is finding and getting enough slack to re-route the wires for the turn signals.

If you look closely at the second picture, you can see how there are brackets attached to the rails. These provide the necessary offset for the lights. The c-bow mounts are attached to these brackets. It's so simple, even I wasn't able to mess them up. The only challenging part is finding and getting enough slack to re-route the wires for the turn signals.
Old thread but still good info.

So, on the turn signals, where did you break/disconnect the wires, at the fuse box or the light?