Adding a Dash Cam - Rexing V1 on CB1100

[EarsOnWheels_imp]

The results:





I later corrected the date, removed the date, removed the license plate stamp, updated the firmware, turned off the impact sensor (was locking/saving clips due to potholes), and turned on the screen saver (turns black after a minute).

If your headlight bleeds, you *will* see it.



But otherwise, low light performance seems decent.



I've covered up the gap between the light and fairing with some electrical tape. I first checked the rubber edging that came with the RC1, but it is not sufficient. Will probably use some black gaff tape later. Also, because wind moves the fairing, it will shake the footage some. I added a foam pad on either side of the instrument panels. We'll see if it helps. I know others have already done this to prevent contact, though that hasn't been an issue for me.