Grip Puppy Installation

[2017EX_imp]

The stock grips on my CB are a bit too small in diameter for me, and result in my hands cramping in a short amount of time. I have been considering Grip Puppies for a while, and have watched the Youtube installation videos, using both the soapy water and air compressor techniques. Using the air compressor looks much easier and faster than the soapy water method to me. Has anyone here used the air compressor method, and if so, how well did it work? I also wondered if they get wet, do they turn into soggy sponges?

I have them as well...heck you may seen my "install" vid. they get a little soggy but will dry out with no problem at all. they were just the right amount of extra beef i needed in the hands

I have them as well...heck you may seen my "install" vid. they get a little soggy but will dry out with no problem at all. they were just the right amount of extra beef i needed in the hands
Mike, Yes I saw your install video...have you seen the air compressor install vid on youtube? Compressor install looked mush easier and faster, so I was looking for feedback on that method. BTW, thanks for the tip on Earpeace plugs. I got a pair and like em. Before your tip I was going to try No Noise ( $30 plus shipping, only 1 filter set, and only 1 set of plugs without the 1 extra for spare ).