LED turn signals

[TXBikerGuy]

For those that want to install LED turn signal bulbs in the stock turn signals or replace the turn signals with LED units, here is what is required.

The stock Honda flasher unit will hyperflash if LED replacement lights are installed.

One can purchase a digital flasher made by Posh for the CB1100. Very easy install, no modification to the wiring harness. I bought the unit from Samurider, just under $100.



The replacement is slightly longer than the stock unit. No fear



Lift gas tank, locate original flasher on left front area under the tank. Disconnect the two electrical connections.



Remove unit, remove the rubber band that holds it in place. Install the rubber band on new flasher unit. Even though the new unit is longer it will fit, just make sure the wire running to the left and around is not trapped under the flasher. Reinstall the tank and you are done. No more hyperflash.

Enjoy!

Thanks to Elipten, my POSH digital flasher unit is on order. Found it at Webike Japan.

Next step - figure out which replacement LED bulbs to install in the OEM turn signal housings. I have some from Dynamic Motorrad in my KTM that are amazing--but they don't make versions that fit the CB1100.

I found [url=https://www.cyclopsadventuresports.com/Super-Bright-1156-BAY15S-LED-TaillightBlinker-Bulb_p_126.html]these at CyclopsAdventureSports. I love their Cyclops LED headlight in my KTM as well. But, no reviews of these on the website so they're an unknown.

Priority is 1) as bright as possible and 2) as clean of a plug-n-play install as possible.

Anybody have any recommendations or experience with specific LED bulbs that are plug-n-play in the 2017 EX OEM housing?