Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Trouble With Shifting From 1st to 2nd & 2nd to 1st
#5
Had a similar problem with mine after I removed the shift lever. It wouldn't shift up into second and stayed in neutral on the down shift. Found out that I had put the lever back on one tooth out on the spline. There is an alignment mark on the shaft and the lever. Once I realigned it all was good.
Reply


Messages In This Thread
RE: Trouble With Shifting From 1st to 2nd & 2nd to 1st - by Tezza_imp - 09-24-2015, 09:28 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Front Wheel Shimmy trouble shooting. JLEECB 5 536 12-27-2024, 02:06 AM
Last Post: mvk24_imp
  Shifting issue Cormanus 31 2,166 05-15-2024, 12:59 AM
Last Post: the Ferret
  Smooth shifting DougsZ28_imp 16 1,333 07-09-2021, 07:32 AM
Last Post: GoldOxide_imp
  No clutch shifting Mixagon_imp 26 1,706 06-21-2021, 10:35 AM
Last Post: cj599_imp
  Trouble shifting CB1100AZ_imp 27 1,872 03-01-2021, 08:25 AM
Last Post: GoldOxide_imp
  I have two challenges... shifting down and checking the oil level Inhouse Bob 15 1,145 02-11-2019, 01:55 PM
Last Post: GoldOxide_imp
  Diagnostic Trouble Codes & Sensor testing SportsterDoc 29 2,220 02-20-2018, 11:08 AM
Last Post: the Ferret
  I fixed my clunky-shifting transmission dave 11 1,282 11-20-2017, 05:22 AM
Last Post: SportsterDoc
  clanking when shifting PilotPaul_imp 53 3,313 11-09-2016, 05:29 AM
Last Post: Ulvetanna_imp
  Bike stalls shifting into 1st gwallis_imp 19 1,195 11-07-2016, 04:10 AM
Last Post: kennyw

Forum Jump:


Users browsing this thread: 2 Guest(s)