05-02-2016, 05:35 AM
Oboro, Well, after looking at the simplified wiring schematic in the ignition section of the manual, I was going to suggest that you try starting with the clutch lever pulled. If it had started, that would point to the neutral switch or the blocking diode.
Anyway, can you read a wiring diagram? If so I can email you the ignition system diagram (not the entire bike diagram). If you have any electrical or electronics knowledge, you will easily see how it works. Hopefully it is not the ECM, but if under warranty, no cost to you. The manual says most problems are connector problems.
Anyway, if you want the diagram, PM me your email address.
Anyway, can you read a wiring diagram? If so I can email you the ignition system diagram (not the entire bike diagram). If you have any electrical or electronics knowledge, you will easily see how it works. Hopefully it is not the ECM, but if under warranty, no cost to you. The manual says most problems are connector problems.
Anyway, if you want the diagram, PM me your email address.