01-12-2018, 08:49 AM
(01-12-2018, 08:31 AM)Mscb1100_imp Wrote:(01-12-2018, 08:19 AM)Aussieflyer_imp Wrote:(01-12-2018, 07:13 AM)Mscb1100_imp Wrote: Does anyone know the lower fork tube measurement in inches and or mm? I need to order some fittings to install some Denali lights I have left over from another project.
Thanks
Not sure where you're planning to mount the lights ...
The section just below the mudguard mount and above disc rotor has room for bracket. It measures 2" OD.
Not sure where you're planning to mount the lights ...
The section just below the mudguard mount and above disc rotor has room for bracket. It measures 2" OD.
On the fork leg just below the fork seal
No mudguard on US models that I know of on the forks
Sent from my iPad using Tapatalk
Not sure where you're planning to mount the lights ...
The section just below the mudguard mount and above disc rotor has room for bracket. It measures 2" OD.
On the fork leg just below the fork seal
No mudguard on US models that I know of on the forks
Sent from my iPad using Tapatalk
The widest OD of the fork lower, where the seal seats, is 62.9mm.
The narrowest OD of the fork lower is 50.9mm.
All models have lugs for a mudguard, perhaps it's a terminology thing. What do you call that half round metal thing over the top of the front wheel ... a fender?