03-28-2018, 09:32 AM
hi i have just change my muffler on my cb1100 2013 i got a emgo mat black some pipe 1 3/4 od
cut a v in the pipe set muffler on the bike wear i wanted it . bent the pipe with v in it to make the angle
i needed to get muffler tight welded pipe cut then ground down weld sliped pipe end in to muffler weld and ground smooth bent a steel bar for hanger using original location on bike then bent 1/8 steel bar to make bracket for center stand weld to pipe used clamp that came with muffler to attached to cb pipe
looks nice clean job would post photos but dont no how to on this site welded a small heat shield to pipe cost of $65 2 hours of my time think it turned out good nice sound put it on you tube this is link i hope https://www.youtube.com/watch?v=5H0dLOzG7ck ps how do you put photos on hear
cut a v in the pipe set muffler on the bike wear i wanted it . bent the pipe with v in it to make the angle
i needed to get muffler tight welded pipe cut then ground down weld sliped pipe end in to muffler weld and ground smooth bent a steel bar for hanger using original location on bike then bent 1/8 steel bar to make bracket for center stand weld to pipe used clamp that came with muffler to attached to cb pipe
looks nice clean job would post photos but dont no how to on this site welded a small heat shield to pipe cost of $65 2 hours of my time think it turned out good nice sound put it on you tube this is link i hope https://www.youtube.com/watch?v=5H0dLOzG7ck ps how do you put photos on hear