06-14-2018, 06:42 AM
There is all kinds of stuff in the way that prevents using the tape measure method from swing arm pivot to rear axle on my EX, shown in the video, and of course there would be the same problem on the right side of the Standard CB. Consequently I have and use the Motion Pro chain alignment tool. The first time I used it I found that the alignment was slightly off, and that as mentioned in the video, the alignment marks on the swing arm ends are not 100% accurate. I already knew that the alignment marks were just a guide, meant to get alignment reasonably close, but there may be some folks that dont know. The Motion Pro tool works, and at an affordable cost.