10-10-2018, 11:11 AM
For someone that is afraid to turn a wrench, you sure can draw pretty computer pictures. 
Why not make 2 cuts? Hack off the mount as you wanted, but then take that same mount you just removed and cut a slice of the 'end cap' to reuse the mounting face. Stick a piece of rubber between if you don't want to rub upon assembly. This seems to be a quick easy solution and would allow you to use your existing parts.
Once cut off, use a bench grinder or a least a dremel to smooth and prep the surface.
Why not make 2 cuts? Hack off the mount as you wanted, but then take that same mount you just removed and cut a slice of the 'end cap' to reuse the mounting face. Stick a piece of rubber between if you don't want to rub upon assembly. This seems to be a quick easy solution and would allow you to use your existing parts.
Once cut off, use a bench grinder or a least a dremel to smooth and prep the surface.