08-31-2018, 08:44 AM
so, my signals arrived. they seem to be surprisingly good quality, and I like the look and size of them for the aesthetic I had in mind. Here's the issue though: I have no idea how i'm going to connect them. The front signals connect somewhere inside the headlight bucket, so I don't think that's going to be problem, but the wires that connect the rear signals are really long, a bit over 3 feet, and the wires that came attached to these signals are very short, less than 12 inches. furthermore, i've seen the connectors from the rear signals, and they're completely different (seen in images below).
So, what's going on here? these signals came as a set of four, which I assumed meant 2 front and 2 rear. is there a particular signal with a longer wire I should have bought for the rear?
Am I supposed to be splicing this somehow? if so, where might i come about a spare wire like the one used to connect my existing signals? it doesn't seem to have a separate part number (part schematic also pictured below).
Anybody ever dealt with this before?
So, what's going on here? these signals came as a set of four, which I assumed meant 2 front and 2 rear. is there a particular signal with a longer wire I should have bought for the rear?
Am I supposed to be splicing this somehow? if so, where might i come about a spare wire like the one used to connect my existing signals? it doesn't seem to have a separate part number (part schematic also pictured below).
Anybody ever dealt with this before?