The CB1100 Community Forum › Honda CB1100 Discussions › Mechanical & Technical v
Bike crank but wouldn't start.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Bike crank but wouldn't start.
GoldOxide_imp Offline
Road Warrior
Posts: 12,677
Threads: 77
Likes Received: 3 in 3 posts
Likes Given: 0
Joined: Dec 2014
#61
03-03-2020, 03:01 AM
(03-03-2020, 12:35 AM)zirconxi_imp Wrote: Thanks Max for the heads up. My cover was off easily with the help of a small plastic tube. i use it as separator when i screw in from the hole use to turn the crank. as the hole screw going in, it push the tube against the bolt use to hold the crank pulse rotor (the gear thingy with missing tooth), thus pushing the cover out. After sensor replaced, the bike fired up right away with the new crank sensor without any problem. Only issue is I have to redo the installation as I had done the gasket dressing wrong the 1st time (only dress the outer perimeter of screw hole). after i packed everything and then realized the oil might leak thru the screw holes, so i redo the dressing again focusing on inner perimeter of screw hole. Anyway, thanks everyone help for solving my problem. Will start to ride tomorrow once my gasket is cured fully. Problem consider solved...

Excellent zirconxi. A good ending.
Find
Reply


Messages In This Thread
RE: Bike crank but wouldn't start. - by Django - 01-23-2020, 01:33 AM
RE: Bike crank but wouldn't start. - by max - 01-23-2020, 02:11 AM
RE: Bike crank but wouldn't start. - by pdedse - 01-23-2020, 02:51 AM
RE: Bike crank but wouldn't start. - by max - 01-23-2020, 05:17 AM
RE: Bike crank but wouldn't start. - by max - 01-23-2020, 01:23 PM
RE: Bike crank but wouldn't start. - by max - 01-27-2020, 06:13 PM
RE: Bike crank but wouldn't start. - by max - 01-28-2020, 03:15 AM
RE: Bike crank but wouldn't start. - by max - 01-28-2020, 05:03 PM
RE: Bike crank but wouldn't start. - by max - 01-28-2020, 08:14 PM
RE: Bike crank but wouldn't start. - by max - 01-29-2020, 01:30 AM
RE: Bike crank but wouldn't start. - by max - 01-29-2020, 12:46 PM
RE: Bike crank but wouldn't start. - by max - 02-01-2020, 12:09 PM
RE: Bike crank but wouldn't start. - by max - 02-04-2020, 03:11 AM
RE: Bike crank but wouldn't start. - by max - 02-06-2020, 03:33 AM
RE: Bike crank but wouldn't start. - by max - 03-02-2020, 06:55 PM
RE: Bike crank but wouldn't start. - by GoldOxide_imp - 03-03-2020, 03:01 AM
RE: Bike crank but wouldn't start. - by max - 03-03-2020, 04:09 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  High engine revs on start up CBX1000_imp 21 1,192 06-06-2024, 02:40 AM
Last Post: Charlie Bravo_imp
  CEL after Jump Start rage91_imp 23 1,053 04-14-2023, 01:25 AM
Last Post: Charlie Bravo_imp
  Should I adjust my crank balancer? DutchRutter 16 793 05-29-2022, 07:39 AM
Last Post: DutchRutter
  Won't start RLS_imp 5 301 05-12-2022, 05:58 AM
Last Post: RLS_imp
  Key Wouldn’t Turn On? sourdough44_imp 37 1,514 08-23-2021, 09:48 AM
Last Post: GoldOxide_imp
  left crank cover calipo223_imp 3 251 05-05-2021, 06:29 AM
Last Post: pekingduck
  CB 1100 won't start GeorgiaRider_imp 30 1,259 12-19-2020, 11:19 PM
Last Post: GoldOxide_imp
  Low rattle on cold start. shahyaan_imp 22 1,030 11-30-2020, 12:01 AM
Last Post: GoldOxide_imp
  Weak Crank Case Bolts? bertypower_imp 19 999 09-12-2020, 10:22 AM
Last Post: bertypower_imp
  strange start pdedse 48 1,632 02-02-2020, 06:34 AM
Last Post: Houtman_imp

Forum Jump:


Users browsing this thread: 1 Guest(s)