Front fork seal Guards, not gators

[Nachodaddy]

Would it be that difficult to make those with a 3Dprinter?

Probably not... but you would run out of ink very quickly during 3D processing and your project could fail before you refill it...

Probably not... but you would run out of ink very quickly during 3D processing and your project could fail before you refill it... :rofl:

 

[Tev62]

I found the fork guards on my 2017EX work very well in shielding crud. I used some Triumph ones I had kicking around which were the same diameter. I did have to bring the twin horns out on some washers though as the guards just caught them.

 

[GoldOxide_imp]

I found the fork guards on my 2017EX work very well in shielding crud. I used some Triumph ones I had kicking around which were the same diameter. I did have to bring the twin horns out on some washers though as the guards just caught them.

I like this shot, Tev.

 

[Gone in 60]

Hmm.. didn't think about the horns. I put slightly smaller ones on my CB, wonder if that would help.

 

[Tev62]

I found the fork guards on my 2017EX work very well in shielding crud. I used some Triumph ones I had kicking around which were the same diameter. I did have to bring the twin horns out on some washers though as the guards just caught them.

I like this shot, Tev.

I like this shot, Tev.
My lads North American spec Ninja EX250F, this colour was never sold in Europe. It is ironic that the modern plastic adorned Ninja is a carburetted 2004 and the chromed up CB is a fuel injected 2017MY.

 

[peterbaron]

New guards already installed and tested on my white CB

My DLX will get them installed this week.

 

[17-CB-002]

Mine is home made from a PCV pipe back in 2017 and not as nice as yours PB.

It is secured via a tie-wrap.

It is tall enough but will not contact the horns during hard braking.

Does the job properly and happy with the price $2.

 

[peterbaron]

…. needs front tire :)

 

[17-CB-002]

…. needs front tire :)

Old picture

New boots is Bridgestone T32 series tires.

 

[peterbaron]

Fork guards for my DLX

 

[Nachodaddy]

Fork guards for my DLX

Looks good, PB