Resistance of Fuel Tank 2014CB1100

[itsok_xman_imp]

Hi All,

Can anyone tell me the resistance of full tank and empty tank of 2014 CB1100?

Since I just change new meter to ACEWELL MD085-553,and the meter show only 1 bar ( I've tried all the options in the meter)

Thank you.

[cj599_imp]

Image deleted for copyright reasons.
i believe this is the us version 2014

[peterbaron]

i_x, this may help you:

http://cb1100forum.com/forum/showthread....LL++speedo

[Lord Popgun]

Looking at the instructions for the meter on the Acewell site, it appears that the closest setting is Full 10 Empty 250. But the instructions seem to indicate you can program in your own setting. Not really clear though. Might have to call them if the values shown by CJ don’t help you.

Just in case the above post gets moderated, the values are Full 5-7ohms, Empty 204-210ohms

[itsok_xman_imp]

Thank you all for the answers.
I am trying to “set up” new meter : gears, speed, odometer, temperature and fuel bars


I had to remove the original meter after an accident.


Sent from my iPhone using Tapatalk

[GoldOxide_imp]

... and while at itsok_xman, welcome to this fine Forum!

[E11even_Hunnit]

Thank you all for the answers.
I am trying to “set up” new meter : gears, speed, odometer, temperature and fuel bars


I had to remove the original meter after an accident.


Sent from my iPhone using Tapatalk

I'm here to tell you- IT"S OKAY, MAN!

Someone will be here shortly to provide wiring pinouts

Are you running the stock forks with the turn signal/cluster gauge bracket?

Would love to see how the whole thing turns out once it's all said and done

[itsok_xman_imp]

Thank you all for the answers.
I am trying to “set up” new meter : gears, speed, odometer, temperature and fuel bars


I had to remove the original meter after an accident.


Sent from my iPhone using Tapatalk

I'm here to tell you- IT"S OKAY, MAN!

Someone will be here shortly to provide wiring pinouts

Are you running the stock forks with the turn signal/cluster gauge bracket?

Would love to see how the whole thing turns out once it's all said and done

I'm here to tell you- IT"S OKAY, MAN!

Someone will be here shortly to provide wiring pinouts

Are you running the stock forks with the turn signal/cluster gauge bracket?

Would love to see how the whole thing turns out once it's all said and done



I installed this one.
Since I haven’t done the set up, so when I ride, it does not show the right number
I am riding ~50mph, it shows 0.1mph lol
And also, it shows the temperature reaches 200F. So sad


Sent from my iPhone using Tapatalk