Pullback risers

[el duque_imp]

I don't mind the bars the way they are. The position seems to work with the little fairing. But it would be a bit more comfortable if they were up and back a little. My only concern is I'll be more upright and maybe a bit more of a target for the wind.

Any suggestions?

[Mscb1100_imp]

I put 2 inch Roxx risers on mine with a taller K&H seat so I’m pretty upright and did not notice any increase in wind drag.

[pdedse]

I used an older version of these on my '14 Standard that made a big difference.
The cables seemed to have just enough play without having to do anything.
The risers bring the bar up and back closer to you.

[url=http://www.twistedthrottle.com/sw-motech-barback-riser-kit-to-fit-22mm-handlebars-for-many-aprilia-bmw-honda-kawasaki-ktm-suzuki-triumph-yamaha-models-30mm-rise-21mm-back-silver]SW-Motech Barback

[url=http://d1l4i7f87txqmq.cloudfront.net/Installation%20Instructions/SW-Motech/LEH/leh_00_039_21000_x.pdf]Mounting instructions gives a good look

I didn't notice any difference with wind, but much more comfortable riding position for me.

[jimgl3_imp]

$16 off Ebay did the same thing as the Roxx. the bottom part was a tad loose. final solution was wrapped once around the middle with safety wire to fill the gap and bolted down. solid as a rock now and you can't tell looking at it.

[Nortoon_imp]

After another forum member suggested them, I bought a pair of GenMar risers. They raise the bars up 1" and back 1 3/8 inches. Unfortunately I will have to wait until May to try them.

[el duque_imp]

thanks.
all good suggestions that i will look into.

[LikeAfox_imp]

$16 off Ebay did the same thing as the Roxx. the bottom part was a tad loose. final solution was wrapped once around the middle with safety wire to fill the gap and bolted down. solid as a rock now and you can't tell looking at it.

Can you link to that or similar item?

[jimgl3_imp]

[url=https://www.ebay.com/itm/Pair-Motorcycle-HandleBar-Handle-Fat-Bar-Mount-Clamps-Riser-Universal-7-8-22mm/173092647013?hash=item284d203065:g:eF0AAOSwWktaWCNt&vxp=mtr]https://www.ebay.com/itm/Pair-Motorcycle...Nt&vxp=mtr

in case that doesn't work, here's the description to search

Pair-Motorcycle-HandleBar-Handle-Fat-Bar-Mount-Clamps-Riser-Universal-7-8-039-039-22mm

[LikeAfox_imp]

Thank you. They are definitely pullback kind, not just straight up risers?

Also, does anyone ever tried using a rubber gasket to decrease vibration? Touring bikes do that upgrade often.

[jimgl3_imp]

yes, they swivel any way you want them. I tried rubber for the slight mis-fit that I described and it worked ok. it did dampen vibration like you suggest, but I just couldn't get used to the lack of a really solid feel to the bars. that's why I finally went with the safety wire.