07-03-2020, 01:01 AM
The plug under the right side cover is for the power to the heated grip kit. As popgun says, it's a switched hot wire and a ground - definitely do not short across it or you could smoke the harness.
The reset is definitely on the left side. There is also a black 4-pin one on the left side stuck inside some sheathing towards the rear - that's not it either. Mine was hard to find, stuck behind all the wires, pretty much in the center of that area.
It is definitely a 4-pin connector, definitely there on the left side, should have a red cap over it. The factory service check connector is a 4-pin and wouldn't work on the 2-pin connector.
The reset is definitely on the left side. There is also a black 4-pin one on the left side stuck inside some sheathing towards the rear - that's not it either. Mine was hard to find, stuck behind all the wires, pretty much in the center of that area.
It is definitely a 4-pin connector, definitely there on the left side, should have a red cap over it. The factory service check connector is a 4-pin and wouldn't work on the 2-pin connector.