11-27-2020, 04:26 PM
(11-27-2020, 03:36 AM)pekingduck_imp Wrote: That particular connector is hard to find, as it has 3 wires crimped to terminals in a very narrow connector. I have seen similar sized in some front turn signals of different brands, but you likely will have to cut the stock taillight wires.
At least you can buy the stock wire and bulb socket if needed.
I wanted to avoid cutting in case I want to revert back. Trying not to mod too much. Also it’s the LED unit on the RS unfortunately it’s the whole unit.
Sent from my iPhone using Tapatalk
(11-27-2020, 04:24 PM)tod.branko_imp Wrote: I cut off the OEM connector from the tail light and then connected it to the LED taillight wires with bullet connectors.
Yes, I know I might want to use the OEM headlight at some point in future, but I'll cross that bridge when I get there
'14 CB1100 STD 5 speed
Just trying to avoid cutting. But I can’t see those connectors here in the UK. Cutting may have to be the way or will see if I can get a second had tail light.
Sent from my iPhone using Tapatalk