connection to control unit with OBD

[bflint]

Here are HealTech OBD sample outputs from my 1st use. FULL DISCLOSURE here ... I have never used an OBD tool and am not a tech. I bought this tool for interest and to hedge my bets for future times when my ride has more years on it. FYI, it did show me a fault message that I have yet to research. Anyway, Attached are some pics and some pdf prints of the outputs.
*
PIC of the tool/computer setup.

*
PIC of tool hookup.

*
PIC of software screen with ignition on and engine off.

*
PIC of software screen with ignition on and engine off and some type of connection fault detection message.

*
PDF report with with ignition on and engine off.

[url=attachment.php?aid=12695]obd.engineoff.pdf (Size: 333.07 KB / Downloads: 10)
*
MORE STUFF ON NEXT POST
SOME MORE OBD PDF REPORTS:
*
PDF Report with engine on and running in neutral.

[url=attachment.php?aid=12696]obd.engineon.neutral.pdf (Size: 332.34 KB / Downloads: 14)
*
PDF Report with engine on and running in 2nd gear.

[url=attachment.php?aid=12697]obd.engineon.2ndgear.pdf (Size: 332.91 KB / Downloads: 17)
*
PDF Report after running in 2nd gear for awhile then switched to neutral (before turning off).

[url=attachment.php?aid=12698]obd.engineon.neutral-2.pdf (Size: 333.55 KB / Downloads: 12)