11-15-2021, 08:54 AM
Yes, research counter-balance adjustment.
Or braze instead of weld?
For those recommending welding, what is the expected failure?
No attempt at sarcasm, just asking.
(11-15-2021, 06:53 AM)max_imp Wrote: Looking at this from an electrical/electronic angle you need to be aware that if there is some welding work done the electronics on the bike ( ecu, meter panel, battery and rectifier just to name a few ) need to be disconnected from the frame ( and verified with an ohm meter).
The frame can act as a transformer in some cases depending how current flows and to have a good weld only to find out something is now not working anymore is something to avoid despite the fact that there are only two earth points in the system, i could be wrong but just something to consider which may not seem obvious, anybody?
Or braze instead of weld?
For those recommending welding, what is the expected failure?
No attempt at sarcasm, just asking.