12-16-2021, 08:04 AM
(12-16-2021, 07:09 AM)max_imp Wrote:(12-15-2021, 06:06 AM)peterbaron_imp Wrote: What about service link, I sent you a little while ago??
Two hydraulic circuits for '14 CB:
front brakes = brake lever, LF caliper, then RF..to be technically correct
rear brakes - brake pedal.
I use vacuum or pressure type bleeders.
First, suck out all the brake (or clutch) fluid, fill up again with fresh DOT4, then start bleeding while watching and topping up reservoir.
When completed, fluid level should equel original reservoir level (assuming there are no external leaks).
At home, I use my vacuum bleeder but one can do bleeding without it = conventional method...by pumping lever or pedal...
If using either one, vacuum or pressure bleeders, I keep pumping brakes at the same time, done thousand brake/clutch flashes on cars and my bikes.
General info: After flushing brakes, I energize ABS pump and repeat bleeding process again to get rid of 99.99% old fluid.
You got me thinking about this part Peter, could be the wording of it but it suggests that there is an electrical way to operate the abs pump, i'm sure i read too much into it but could you clarify this?
And for others; the abs module is only an intervention in both break systems, normally similar to refreshing the fluid but more prone to air buildup in the lines due to the effect that unlike standard systems the air is not automatically able to rise through a passage at the highest point and escape into the fluid container but can build up in a high point in the brake lines.
The only way to clear this is a quick flush so the fluid is faster which expels the trapped air.
I think this would be the way to go, if I ever get around removing the coffee from my lines.
