The OBSERVED Valve Clearance thread

[max]

Thanks Jurly, you're right on the money, inserting the tool and screwing it in is the right way, also see this thread;
http://cb1100forum.com/forum/showthread.php?tid=8677

For anybody who needs such a tool here is a youtube video with an alternative:
https://www.youtube.com/watch?v=YiEomqC-UBI

And here is what i made and just tested on my cb1100;



It is made out of 1 mm. copper sheet because it was easy to cut and is strong enough to do the job, i have previously used it on my cb919 hornet, the bolt next to it is m6 for size reference.

Thanks again for all your work, when i have some time i will enter it into the spreadsheet if that's ok with you.