05-08-2020, 07:08 PM
That is quite an accomplishment speed, thanks a lot for the pictures.
I have always wondered what the iacv looked like inside, you can see the poles inside and the offset of the two coils to produce the different step positions, these steps are very small indeed, can you measure if the rotor has more than two poles with another magnet?
It will be interesting to see the outcome of Pawel's tesrting, you guys have contributed a lot of information!
So it does not look like something is out of alignment by the absence of any scratches, we have never seen any.
What i did notice is that the mounting plate with the two screws only fits correctly one way, when it captures and locks the notch in place and that was correctly mounted in your very first picture labelled "progress so far" so no factory mistake there.
Oh and please don't throw any bits away, we may need to look at them a little closer after the thinking has focused some, how's the moustache? took me a while to figure that one out
I have always wondered what the iacv looked like inside, you can see the poles inside and the offset of the two coils to produce the different step positions, these steps are very small indeed, can you measure if the rotor has more than two poles with another magnet?
It will be interesting to see the outcome of Pawel's tesrting, you guys have contributed a lot of information!
So it does not look like something is out of alignment by the absence of any scratches, we have never seen any.
What i did notice is that the mounting plate with the two screws only fits correctly one way, when it captures and locks the notch in place and that was correctly mounted in your very first picture labelled "progress so far" so no factory mistake there.
Oh and please don't throw any bits away, we may need to look at them a little closer after the thinking has focused some, how's the moustache? took me a while to figure that one out