04-24-2020, 06:30 AM
These are the settings of the scope
![[Image: af956513636e6488f5c13e2bab5560b3.jpg]](https://cb1100forum.net/forum/uploads/imp/202004/af956513636e6488f5c13e2bab5560b3.jpg)
I checked both IACV coils buit in the image I was checking coil 1, Black/Yellow (A6) and Black Orange (a7) wires where I connected the oscilo. Both coils give similar readings.
![[Image: 043fe8f81c5d1c0d7ad10743567efa24.jpg]](https://cb1100forum.net/forum/uploads/imp/202004/043fe8f81c5d1c0d7ad10743567efa24.jpg)
I was not expecting values from 0V to 12V and -12V in the same coil. In the other hand, the only method for reading codes without the MCS is the blink code which will appear when setting ignition ON and side or central stand down? Am I wrong? MIL light has never appeared in the lifetime of the bike... and also have never seen any blinking code. Thanks everyone for any help given!
I checked both IACV coils buit in the image I was checking coil 1, Black/Yellow (A6) and Black Orange (a7) wires where I connected the oscilo. Both coils give similar readings.
I was not expecting values from 0V to 12V and -12V in the same coil. In the other hand, the only method for reading codes without the MCS is the blink code which will appear when setting ignition ON and side or central stand down? Am I wrong? MIL light has never appeared in the lifetime of the bike... and also have never seen any blinking code. Thanks everyone for any help given!