08-27-2018, 11:56 AM
(08-27-2018, 11:36 AM)Lord Popgun_imp Wrote: Dave, open the vid. Run the cursor to the 19 min point and click run.
Personally, I’m not seeing it. He already has the throttle body off the bike (not a CB1100).
The end was pretty neat where he shows his rig for cleaning injectors.
So what would happen if you leave the whole bike intact, lift the tank, remove only the right hand black throttle body cover and just take out the three security torx screws for the iacv plate from the top.
unclip the 4 pole connector and lift the iacv up and out of the bike, swap the iacv, put the plate with new iacv back in the bike and re-connect the 4 pole connector; that's all.
That is what he does at 20 minutes, our bike stays together.
Yes it's a different model bike but the throttle body is the same.
What do you think, Dave?
Even if you are taking your time it could be swapped inside one hour.
Does the service manual mention anything about replacing the iacv popgun?