06-04-2018, 02:39 AM
Dave, did you send the original IACV to peterbaron?
If so, and nothing found out of spec, I would suspect that it got out of position and was unable to recover home position. That is a problem with a stepper motor, unless it has a home position sensor.
Max, you offered some suggestions to get it to home. Any further thoughts?
In other words, if the IACV is not defective, and if re-position instructions could be offered, it may save others going through a replacement.
Due to family arriving this week and a vacation to the Pacific Northwest and British Canada the next two weeks after, I may not reach 10,000 miles on the odometer (9,360 now) until the end of the month/early July. Very much enjoyed the 712 mile trip to Arizona last Thu-Sat on the CB, averaging 53.18 MPG.
If so, and nothing found out of spec, I would suspect that it got out of position and was unable to recover home position. That is a problem with a stepper motor, unless it has a home position sensor.
Max, you offered some suggestions to get it to home. Any further thoughts?
In other words, if the IACV is not defective, and if re-position instructions could be offered, it may save others going through a replacement.
Due to family arriving this week and a vacation to the Pacific Northwest and British Canada the next two weeks after, I may not reach 10,000 miles on the odometer (9,360 now) until the end of the month/early July. Very much enjoyed the 712 mile trip to Arizona last Thu-Sat on the CB, averaging 53.18 MPG.