CB1100 Idle speed instability problem

[max]

Thanks pdedse, i was going to ask about this fix, i would not exclude the tps connector, you are now the second to have cured your issue, that i s good news.
Also thanks for the tho links, that helped a lot jdvalero had a low voltage code, so the pin in question was actually the leftmost one, ( +5v ) i think, if it makes bad contact it will open and the voltage will go low.
He correctly states that he THINKS the one he poins at is suspect but it is not.

I like to thank him for taking the picture and posting the fix!

The way the tps connector is installed bothers me a bit, the small wires may be under stress, so it's also a suspect in my opinion and if anyone has a look at theirs be advised to not force the connector in the tps, it should connect fairly easy, if not the contacts could end up mis-aligned and to provide some room in the wiring the tank needs to be lifted and the plastic cover removed with a philips screwdriver.

i also like to stress that trying to adjust the tps by rotating it is not recommended at all unless a very good understanding is achieved on how to proceed, pogun advised this and i would like to repeat his wise words.

Thanks all for the input max