04-30-2022, 01:38 AM
(04-10-2022, 04:20 AM)Ollie_imp Wrote:(04-07-2022, 08:23 AM)Classico_imp Wrote: I’ve some light rust patches on mudguards’ interior.
They are superficial but i want to get rid of them asap. I think I’ll clear them with sandapaper or some abrassive brush drill, then paint them with some protection product. Someone been there before? Any advice on how to proceed?
Yeah I noticed the same when I had the fender off to install a Extnda Fenda. I lightly sanded, cleaned, and coated the rust with Rust Converter, then painted the whole area with oil based enamel.
On mine it wasn't really the fender so much as the sheet metal brace attached to the fender. I posted about it here:
Yeah I noticed the same when I had the fender off to install a Extnda Fenda. I lightly sanded, cleaned, and coated the rust with Rust Converter, then painted the whole area with oil based enamel.
On mine it wasn't really the fender so much as the sheet metal brace attached to the fender. I posted about it here:
My fender looked similar to this, but worse. And this is on a bike that has seen light drizzle on it only twice in it's lifetime. Also, it is in San Diego, away from the coast, and stored in a garage.