08-26-2025, 06:28 AM
No to both questions. The service manual just says to torque them. They are not shown as special bolts in the torque spec section or mentioned as special in section 7 (cylinder heads/valves) in removal and re-installation.
For the cam flange holder bolts it says to put engine oil on the threads and seating surface.
For the sprocket bolts it says apply a locking agent. Book says use medium strength unless otherwise specified. Nothing specified so use medium.
It also shows/says the flange holders must be loosened and tightened in a several steps in a crisscross pattern from outside to inside or they may break. And do not forcibly remove the dowel pins from the camshaft holders.
For the cam flange holder bolts it says to put engine oil on the threads and seating surface.
For the sprocket bolts it says apply a locking agent. Book says use medium strength unless otherwise specified. Nothing specified so use medium.
It also shows/says the flange holders must be loosened and tightened in a several steps in a crisscross pattern from outside to inside or they may break. And do not forcibly remove the dowel pins from the camshaft holders.
Holder of the CB1100forum Secret Decoder Ring
2012 ST1300
2013 CB1100
I find your lack of RLETs disturbing
2012 ST1300
2013 CB1100
I find your lack of RLETs disturbing