Tail lamp harness

[CBXBob_imp]

What a let down!
I got it installed today and will add a picture as soon as my phone recharges. But I have to say the quality on the J&P lamp is pretty poor. And for only $43 I wasn't expecting a lot. The hardware is crap, the rubber base gasket is deformed and the lamp socket is junk.
But the body looks good.

Got mine from a different supplier but I'm sure it is similar. Yes, the base gasket wouldn't lay flat so I used a bit of clear sealant to hold it to the contour of the fender before I screwed down the taillight.

The lamp socket is kind of light weight, but not much different than what I've seen before. The supplied bulb IS WEAK and I was worried if drivers behind me could see me stopping. There isn't a nice reflector behind the bulb to diffuse the light like the stock one so I got a SuperBright LED bulb to replace the weak aftermarket bulb supplied in the kit.

But ...... after all the work that low profile taillight does look good!

Aloha,
Huladog

Got mine from a different supplier but I'm sure it is similar. Yes, the base gasket wouldn't lay flat so I used a bit of clear sealant to hold it to the contour of the fender before I screwed down the taillight.

The lamp socket is kind of light weight, but not much different than what I've seen before. The supplied bulb IS WEAK and I was worried if drivers behind me could see me stopping. There isn't a nice reflector behind the bulb to diffuse the light like the stock one so I got a SuperBright LED bulb to replace the weak aftermarket bulb supplied in the kit.

But ...... after all the work that low profile taillight does look good!

Aloha,
Huladog
I used Posi-lock T connectors due to limited space and positive screw connections . tried to post pic from phone but couldn't make work. Just had rotator cuff surgery so down and out for a while. Installed Hyperlites using their license plate bracket, and a black LED license plate frame. CBXBob.