Chip Beck Spec Corbin Seat

[GUNFTR_imp]

Seat arrived yesterday and was correct this time. I heeded some advice I had seen somewhere about the latch perhaps being a bit tight and added a two small washers under the attachment on the seat that hooks down into the latch. Seat latches in and unlatches perfectly. This is also the first Corbin I've ever had that has a plastic seat base. Normally, they've been metal and the entire seat has been very heavy. This one is not, and weighs about the same as the stocker.

I have not ridden it yet, but did sit on it in the garage and there is a noticeable pocket where you sit which feels wide and comfortable. The passenger area is also about 1/2 wider on each side up top with a modest cupped area for the occasional passenger.

I am very happy with it so far. Not sure why it took a full five weeks to make the replacement when the original came in half that time, but at least they made it right.