Lockhart Phillips Turn Signals-Lucas Tail Light

[roadrash7_imp]

Here is how I did the ship in a bottle install for the front turn signals. I removed the headlight bulb then removed the 4 allen bolts that hold the headlight bucket so I would not have to worry about aiming the headlight when I replaced it. I removed the old turn signals, disconnected the wires inside the headlight bucket. Then drilled the larger 3/8 hole. Here's the fun part. You need a 3/8x1-1/4 fender washer on the treaded part of turn signal on the outside of the bracket. Now put the wire and the thread part through your newly drilled hole, take a 3/8x1 fender washer, lock washer and the nut run it down the wire. You can start the threading of nut by putting one of your fingers inside the bracket. Now when you reach the last few threads to really get it tight, I removed my finger and used a small opened end wrench to catch the flats on just the bottom of the nut. Now turn the turn signal housing from the outside and you can tighten it down... The rear turn signal were really easy, but on my 2014 standard the wire were reversed. As someone mentioned in a earlier post.