Chip Beck Spec Low Handlebar/Mirrors Mod.

[ChipBeck_imp]

Excellent write up, thanks! Did you get a pic of the drilled holes / location, that seems to be the only part of the installation which can go pear shaped.

I did not photograph that because a photo wouldn't do much good. I just looked at the positioning hole on the underside of the stock handlebar (there is one on each side), found a largest size drill bit could squeeze into that hole in the stock bar, carefully measured the location of those two holes on the stock bar in relation to the bar end, marked the location on my new bar, drilled a smaller pilot hole, and then drilled the full size hole. Everything fit perfectly. Measure twice, drill once!! If the hole is a fraction off or a fraction too big it won't matter much as it's covered up once the controls are in place.

Chip