New Rear Carrier and Makeshift Backrest

[CB4ME_imp]

I recommend starting the carrier install by inserting but not tightening the bolts nearest the seat first.

The turn signal mounts will bend just enough to get the bolts into place (the signals are on semi-flexible stalks). With everything lined up the bolts will push all the way in. "Everything in place" includes that small bracket that's at the base of the turn signal mount. It has a hole for the bolt.

Back out the bolt enough to begin threading the nut. Then use a 6mm hex wrench to tighten - careful not to scratch the turn signal housing.

Good luck and get those spacers.