Red Side Covers Finally

[redbirds_imp]

The 2013 CB has always been my favorite model albeit all models have their strong points. The only burr under the saddle has been the silver side covers; to me they look like primer coated doors on a car. The price of replacement covers in body color are too costly for me so after putting it off for years now, I ordered paint in base and body color from Color Rite. I have followed the Color Rite directions sent with the paint and the process went surprisingly well.

First step was to remove the CB1100 emblems without damaging them. A blow dryer and some dental floss made this job easy with no marring of the covers.

[url=http://s1259.photobucket.com/user/stumpshooter/media/20170402_3_zpsswlcudna.jpg.html]

I taped off the black upper part of the covers and found a crack in the right side cover near the mounting bolt hole. This was repaired with a thin piece of sheet steel and some JB Weld epoxy.

[url=http://s1259.photobucket.com/user/stumpshooter/media/20170402_7_zpsd4mpkyy6.jpg.html]

[url=http://s1259.photobucket.com/user/stumpshooter/media/20170402_9_zpsucm7jtmi.jpg.html]

Next the covers were sanded with 600 grit sandpaper and finished with 0000 steel wool. One coat of primer was applied.

[url=http://s1259.photobucket.com/user/stumpshooter/media/20170402_12_zpsrlnlgodf.jpg.html]

After allowing the primer to dry thoroughly, two coats of the Color Rite base color was applied allowing about 20 minutes between coats.

[url=http://s1259.photobucket.com/user/stumpshooter/media/20170402_13_zpsoluh5zpu.jpg.html]

Then three coats of Color Rite Candy Glory Red allowing adequate drying between coats.

[url=http://s1259.photobucket.com/user/stumpshooter/media/20170402_15_zpssidhwfgy.jpg.html]

After allowing an hour drying time, the masking tape was removed. This required using an Exacto knife to carefully trace along the tape's edge so as not to pull the paint. Three coats of the Color Rite clear coat were applied, 20 minutes drying time between coats.

[url=http://s1259.photobucket.com/user/stumpshooter/media/20170402_19_zpsujicpj8u.jpg.html]

[url=http://s1259.photobucket.com/user/stumpshooter/media/20170402_22_zpslptbmnsy.jpg.html]

I will replace the emblems tomorrow using outdoor rated double sided tape by 3M and post a few pics with the covers on the bike.