Good grips for CB1100? Which ones are you all installing?

[rdtshaw_imp]

Hey fellow CB1100 goobs... I meant to post this earlier, but here are some pics of the OURY grips and the install. I am very happy with them. They are about 3mm thicker diameter than the stock, just enough to add the cushion I wanted without being odd to hold on to. They are a bit too sticky texture wise at first, but after a couple rides, they are better. They were $13 bucks shipped from amazon. To top it off, the bike on the package just says, "Put me on your CB!" They come with the ends closed, but a quick outpatient surgery will square that away so the bar ends can be reinstalled.



----------------------------------
I used Isopropyl alcohol and the syringe to get under the old grips and slide them off, took a little work. I didn't want to cut them off. I put some of the alcohol in the new grip and slid it right on. after a couple hours it was on solid. Did the same with both sides.



---------------------------------
Here is the new Oury grip next to the stock.



---------------------------------
After sliding the grip on, just need to x-acto a hole in the end.





---------------------------------
All done! Slide the bar end back on and screw it in. Repeat on the other side.