Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Center stand mod for Yoshimura system
Author Message
Razor Offline
Been There


Posts: 395
Threads: 31
Likes Received: 58 in 13 posts
Likes Given: 12
Joined: May 2025
RE: Center stand mod for Yoshimura system
#6

Thanks, plan is to put a few miles and uses on the stand and make adjustments if needed. Then pull the two pieces off, clean them up & powder coat them.


(10-17-2014, 06:17 AM)EmptySea_imp Wrote: I think this whole thread is a fabrication. ROFL

i'll be here all week. don't forget to tip your waitresses.

MT, you are correct my friend Big Grin


10-17-2014, 10:05 PM
Find Reply


Messages In This Thread
RE: Center stand mod for Yoshimura system - by Razor - 10-17-2014, 10:05 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Yoshimura RS3 replacement for an '13 Jurlie_imp 7 490 07-28-2024, 01:47 PM
Last Post: Glockrocks83_imp
  Stand-alone ECU TTRacer_imp 2 225 02-22-2024, 01:58 PM
Last Post: TTRacer_imp
  Exhaust system/slip-on johnny_elpino_imp 26 1,624 05-26-2023, 01:06 AM
Last Post: kzoorue_imp
  Yoshimura RSCV Full Exhaust System Stealth128_imp 43 2,876 11-29-2022, 10:38 AM
Last Post: mrded_imp
  Dart flyscreen and a little Yoshimura stain magic 1985CB450_imp 19 1,380 10-24-2022, 04:12 AM
Last Post: 1985CB450_imp
  Advice - carry water bottle and side stand plate? 4 Paws_imp 41 1,903 07-23-2022, 06:02 PM
Last Post: rich_imp
  Installation of a Smart Turn System [No Cut Mod] LayerCake_imp 20 1,376 06-15-2022, 01:28 AM
Last Post: KiowaEagle_imp
  Yoshimura RS3 Install. 2013 Kit on a 2014 and sorted the center stand issue! rdtshaw_imp 17 878 01-05-2022, 10:54 PM
Last Post: Nibis_imp
  DLX Exhaust System Conversion Ron in MO_imp 28 1,329 08-26-2021, 10:50 AM
Last Post: bvictory_imp
  hepco becker side back C system alexzanutto_imp 16 1,092 07-31-2021, 07:34 AM
Last Post: Inhouse Bob

Forum Jump:


Users browsing this thread: 1 Guest(s)