Clean pair valve..mod

[3rdcoastcb1100_imp]

I’ve seen a couple of pair valve mod jobs and figured I’d offer up another option for those who are interested. I will add that this is pretty simple and straight forward. This kit will run you $45 usd.

The kit has billet block offs plus the necessary hardware
1 cap to plug off the inlet into the air box
1 plug for the harness so you don’t toss a CEL

1. Pull the seat
2. Pull both side covers
3. Pull tank by removing the vent tube and disconnecting the fuel line (Don’t forget step 2 because the black connector is the fuel pump)
4. Under the neck, locate the air pump and unplug it
5. Use the supplied bypass plug and tuck everything under the harness
6. Remove the pump assy.
7. Pull all the related hoses. The longest hose runs to the airbox where you will use the supplied cap to plug it off. It helps to have the covers off.
8. Remove the oem pair covers.
9. I opted to gut the reeds but use the rubber bodies to help with sealing.
10. Reinstall tank and plug fuel pump back in. Be sure to prime the system to make sure you have no leaks.
11. Install side covers and seat. Done