Delkevic exhaust, experience?

[mvk24_imp]

yes. no birds nest in there. it made a notable difference in acceleration. the whole system i got was under 400 bucks, stainless. very very happy with it. finally, 3 years later, going to send the ecu off to get reflashed next week i hope.

Ah very nice, I actually had an issue after the ECU flash where my bike did not want to just cruise at highway speeds. The bike wouldn't run smooth at 60 or 70 mph. I would have to accelerate to 75 or 80.

A power commander fixed the problem but if I could do it again maybe i wouldn't have done the ECU flash in hindsight. All I needed was to eliminate the speed limiter but my mechanic had them change the ignition timing and raise the speed limiter also.

Now I inevitably have to do a custom tune with the power commander which will set me back another 500$ but I'm not gonna do a custom tune on a nearly stock bike... so I'm boring out the intake funnels and gonna do a full exhaust. Then do the custom dyno tune.... you see where one expense leads to the next haha
From what I've seen on here I should be able to get 100hp to the rear wheel. Which I think will happen sooner than later now that I could use a delkevic header instead of a full yoshi

Sent from my SM-G965U1 using Tapatalk