Guhl Tune/Derestriction

[mvk24_imp]

Thanks guys! Appreciate the props!

I'll take some closer pics of the exhaust and post them as well. The fabricator/builder is absolutely outstanding, and his welds are works of art in themselves. While he was working on my bike, he just finished a KZ for a client and that bike was just recently in PipeBurn. He also finished a CB750 which was exceptional as well. I got a pic of them together I will also share.

Mvk24 - I had the fenders powdercoated by a company here in VA, ASCO. I've used them a lot over the years for tons of motorcycle parts and several sets of wheels for my car and truck. I did rattle can the taillight housing myself though since it is metal over a plastic frame and couldn't be PC'd. I sanded, scotchbrited, wiped it with degreaser, washed, then dried it thoroughly. Then used several coats of etching primer and gloss black. Finished it off with two coats of clear and hand buffed it out. It came out pretty good, I guess my OCD pays off at times haha

Oh and yeah, the rear fender is a bit of a pain. The taillight wire snakes through the fender, its very clean but disassembly and reassembly is a little time consuming.

Haha nice! I'm the same way it i do it i have to go through the entire process to do it the right way so I wanted to avoid paint.

I just did the vinyl wrap to the headlight brackets and it came out looking like the factory did it. Theyre pretty simple and flat thought.

I did a carbon vinyl wrap to my KZ440 tank on the third rebuild and that was a whole different story.. again because I'm anal and had to get every single wrinkle out. That took about 2 days and 2 attempts each because my buddy melted the wrap on me halfway through the tank lmao

Sent from my SM-G965U1 using Tapatalk