(03-08-2018, 11:36 AM)CaptainChris_imp Wrote: Yup this is what I'm looking at. My other question is the connectors on the wire harness.. I'm not sure if they're the same or not between the two models from looking at this.
I wouldn’t sweat the connectors. Most 12V horns have similar terminals for interchangeability. Worst case, you could splice in the right connector or solder direct for a less bulky look.
Once I get my RC1 fairing installed, I think I’m going to look at crafting a new bracket to push my ‘14 horns closer together, lower and back towards the steering stem so they are less conspicuous and not partially covered by the fairing.